Capture Some Sunshine!

Step-by-Step Instructions

1. LAY OUT FLOWERPOT HOLES. Position the end holes so that the centers are 7" from both ends of the main shelf (A) and the edge of the hole is 1/2" from the front edge. Draw the cutting lines with a compass so the holes are slightly smaller than the lip of your pot. Space the remaining holes evenly between the two end holes. Bore an entry hole with a spade bit for sawing.

2. ENLARGE PATTERNS for the upper backboard (make two copies) and the wood brackets. Tape the backboard pattern together to make the full pattern. Center and tape it to the backboard. Tape the bracket patterns along the squared end of a board and the perpendicular edge. Cut and sand smooth.

3. ATTACH THE MAIN SHELF to the lower backboard with 2" screws. Drill and countersink the holes to keep wood from splitting. Make sure you're not attaching the edge you marked as "front."

4. FASTEN THE BRACKETS to the upper backboard flush to the bottom. Then center the backboard on the main shelf and attach the brackets from the underside using 1-5/8" screws. Glue and nail the front edge trim in place, countersinking the nails. Apply your favorite outdoor finish to protect the shelf's good looks.
In this Story
1. Capture Some Sunshine!
2. Step-by-step Instructions
3. Cutting List and Shopping List
4. Diagrams